![]() |
|
|
|
#1
|
||||
|
||||
|
I thought maybe it was because the two knobs and speaker grill kinda look like a hippo smiling ?
![]() Perhaps you could drive some dowels into a scrap of plywood to make a rectangular form. Just the right size to slip inside the back of the cabinet. Then wrap your wire around it being careful not to overlap and glue it together to form a ribbon. When the glue sets up slide it off and mount in the radio. I used some two-part epoxy to affix mine to the cabinet. Last edited by bandersen; 03-21-2011 at 01:22 PM. |
|
#2
|
||||
|
||||
|
Hi Bandersen,
Sure.. that should work. Didn't the old door bell wire come in a cloth covered style.. Might be too large of a gauge of wire to work here. The bigger the wire the more I'll need to make a 2.6 ohm loop. I'll have to spend more time searching Ebay and other sites. Yes, I think you've got it. It does look like a Hippo smile. Must be it! I looked at that site that has the repo-backs for sale, and they mention in the FAQ section that no clips for the back have been designed or made to sell for the Hippo. So my search goes on. ![]() As I remember.. about the time I ripped into the radio, it was humming. The folks just kept playing it that way until you couldn't understand what was going on... kinda funny, I can still here the newscaster in the background under the Hummmmmm! Amazing what one can remember from the "early" years. Fond memories. ![]() Buzz |
![]() |
| Thread Tools | |
| Display Modes | |
|
|