Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 02-23-2011, 04:26 AM
bandersen's Avatar
bandersen bandersen is online now
RCA 741PCS
 
Join Date: Mar 2009
Location: Chicago, IL
Posts: 8,829
Quote:
Originally Posted by Tubejunke View Post
I take it that the diode has a similar forward resistance as the old wire-wound resistor had in order to maintain the proper voltage. I am sort of new to the whole concept of replacing one component with a totally different, more modern component. I have read up a bit on eliminating 5U4s or other tube diodes used in a rectifier configuration, and replacing them with silicon diodes and a resistor to drop the same voltage as the tube filament. I have seen a few sets with the selenium rectifier disconnected and some older (germanium?) solid state diode(s) wired in its place. I thought that selenium rectifiers tended to run a bit hot, hence the cooling fins. I KNOW that they smell terrible when the finally do burn up, but the few that I have seen burn up were caused by bad electrolytics.

The silicon diodes have a lower resistance than the seleniums. That's why I have to increase the 10 ohm resistor to 22 ohms. I actually used a 32 and 75 in parallel each rated at something like 25 watts because that's all I had on hand. Really I think a 5-10 W would be fine.

As for using a diode in the filament string, that's a new concept to me as well. I first heard about it a while back as a potential replacement for the nasty VT71 ballast. I didn't actually try it until a few weeks ago in a Philco 37-611 radio. So cool that one little bitty device can replace a big 20W resistor and generate virtually no heat.

There is nothing wrong with the huge, original resistor and I could have left it alone. However, this little set uses around 130 watts and I figure any heat savings are a good idea.
__________________
Here are my Vintage Radio & TV YouTube Channel and Photo Gallery
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:27 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.