![]() |
|
|
|
#1
|
||||
|
||||
|
Huh, maybe I should replace the brownies in the vert circuit of my CTC-9. It's always had a slight lack of height, and the vert linearity could be better too.
__________________
Evolution... |
|
#2
|
||||
|
||||
|
i replaced the brownies on my ctc10 vertical circuit and the height and linerity came back just like new. steve
|
|
#3
|
|||
|
|||
|
Thats why I like my cap tester, great for checking those caps, shows up weak ones vert quickly.
Interesing note on cap testers, this got me once so now I always remember to disconnect the video feed from the dvd player to the TV. I have no idea why but if you leave it connected, sometimes a cap will read weak (fuzzy eye opening) if one leg was lifted for the test (so one leg is still in the circuit). There is a .1 1kv white tube cap that test ok but I can't test over 450v so I may just replace it anyway. Not looking forward to pulling the chassis, it looks like its going to be a pita, lots of tied off wire cables. This seems to be a low end zenith based on all the missing (unused) adj pots on the back of the chassis, and the cheapie IF tubes (6BZ6 on the 1st 2). |
|
#4
|
|||
|
|||
|
Thinks its time to check the cathode voltages, CRT seems dark, even with the lower kv (22kv tops HV adj as high as it will go, still 1.6v drop (1.6ma) on the shunt tube) it seems like it should be brighter. The fact that I am not getting any contrast control makes me think the video amp is not right, perhaps cutting off the CRT. looks like I will have to pull the chassis soon to get much further.
|
|
#5
|
|||
|
|||
|
a few more checks, the CRT cathodes 260v and the screen grid around 650v so all good there.
|
| Audiokarma |
|
#6
|
|||
|
|||
|
progress, at least on the picture, had a open cap in the contrast circuit, much better pic now. Purity and convergence all jacked up, prob from my flipping it around so many times, I may have bumped the static convergence, but the pic is much better. Purity is a mess, but I can work on that later.
the cathode cap was in a can so good chance the others in that can are bad (screen bypass on the video amp was one, not sure about the others). replaced the cap on the shunt (.022 grid to cathode) thinking it may be leaky, it was not, no change in shunt current still high and hv low (21-22kv). I am going to take another look at the 1.5 meg to ground in the grid circuit of the shunt. It now seems like that is the only thing that could account for to high a grid voltage, unless for some reason the boost voltage is way, but not sure how that could be. |
|
#7
|
|||
|
|||
|
HV progress. I think I had incorrectly check the 1.5 meg to ground, I jumped in a 2.2 meg and everything works as it should. Can't say for sure that the 1.5 is bad and my 2.2 is just compensating for some other problem until I get a sams resistance reading as I think there are other part making a in circuit reading inconclusive.
If I had pulled the chassis to check it I prob would have found this a while ago, its just a major pita. Last edited by DaveWM; 12-09-2010 at 08:08 PM. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|