Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Vintage TV & Radio Tech Forum

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #4  
Old 11-04-2010, 06:48 PM
Reece's Avatar
Reece Reece is offline
VideoKarma Member
 
Join Date: Jul 2004
Location: Cleona, PA
Posts: 2,178
Don't think the AC plug is the problem. C1A should definitely greatly peak a weak station at the high end of the band. Right now NostalgiaAir is down but schematic can be seen at

http://techpreservation.dyndns.org/s...53-561_80.djvu

Check that the loop is connected properly. Per the schematic, the outside winding of the loop goes through a 944 mmfd. (or pf) cap shown as C2 on the pictorial to the stator of the rear section of the tuning cap. Also through the bandswitch when in broadcast band position the outside winding gets a direct connection to the rear stator. The inside winding of the loop connects directly to the tuning cap rotor (frame.) On the pictorial attached to the schematic I don't see that wire shown, and wonder if the inside of the loop got inadvertently connected to the outer end of L2? It is connected there, but also perhaps through internal wiring to the cap frame? Hard to tell without tracing the underchassis wiring.

What were the two rectangular caps you replaced, and what values? The old ones may be OK.
__________________
Reece

Perfection is hard to reach with a screwdriver.

Last edited by Reece; 11-04-2010 at 06:56 PM.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:31 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.