![]() |
|
|
|
#1
|
||||
|
||||
|
Quote:
Dave, What is the "power factor" you refer to - and how do you test it? I've heard of value, ESR, leakage, and dielectric absorption tests for e caps, but this is the first I've heard of power factor. Cheers,
__________________
Brian USN RET 22YRS (Avionics/Cal) CET-Consumer Repair and Avionics ('88) "Capacitor Cosmetologist since '79" When fuses go to work, they quit! |
|
#2
|
||||
|
||||
|
that is an e 40 chassis.decent set,not quite as good as the 41,45,48.still pretty good.you have to loosen collar around yoke and move convergence board also to get purity.very easy.may have to degauss first.my mother bought a new set just like this.9 years later,she sold and bought a new xl100.worstset she ever had.dim picture,many service issues.i got her a e-45.she used it until i bought her the first 36 inch flat crt toshiba.that 45 is in her bedroom as a spare.still playing and still looking sharp!
|
|
#3
|
|||
|
|||
|
I use an old heatkit condenser check (uses an eye tube, and a balanced bridge cirsuit for check caps) good of vintage gear esp leakage test at rated voltage, but can not check caps in circuit. there is a "power factor" adjustment, you turn to null the eye tube, which I think is about the same as ESR.
|
|
#4
|
||||
|
||||
|
Quote:
Thanks! I've got some old Heath stuff - I'll have to see what I've got stashed away. I may have one of them varmits. Probably similar to my Sprague tester's eye tube checks - some kind of reactance vs value check. Cheers,
__________________
Brian USN RET 22YRS (Avionics/Cal) CET-Consumer Repair and Avionics ('88) "Capacitor Cosmetologist since '79" When fuses go to work, they quit! |
|
#5
|
|||
|
|||
|
I think I may have found the vert prob, after going thru every cap (all good) I finally did a swap on one of the vert out transistors, but now the stupid converter box is on the fritiz so I cant get a signal to check it out on. I cant believe what pure junk these DTV boxes are, this is the second one that went out, less than a year old. I have other video RF sources, but it will have to wait for a bit.
I did a quick check last nite and it looked fixed, so I was going to check again this am. |
| Audiokarma |
|
#6
|
||||
|
||||
|
good job.those vertical transistors can have dirty socket issues.had more than a few.post more pics.the crt looks sharp and bright.
|
|
#7
|
||||
|
||||
|
Watch out for the vertical controls. I have replaced many of them for the problems you describe.
|
|
#8
|
|||
|
|||
|
the little pots on the back of the pcb? should I try an test them in circuit?
I have cleaned the transistor sockets, and the serv switch. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|