Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #2  
Old 09-17-2010, 11:15 PM
bandersen's Avatar
bandersen bandersen is offline
RCA 741PCS
 
Join Date: Mar 2009
Location: Chicago, IL
Posts: 8,829
I noticed that the top was made up of several strips of veneer. So, my first thought was to just replace the bad ones.


I was concerned that the new strips would stand out too much so took it all off. I tried heat and steam, but no luck and reverted to brute force.
I saved the large scraps to use as patches elsewhere.


My next thought was to go old school and join the edges of my veneer strips with veneer tape and try to glue them down while maintaining a tight seam. Then I saw jeyurkon's Sylvania restoration project and the large sheet of veneer he used. I inquired and found out it came from veneersupplies.com. So I ordered up a nice 2' x 8' sheet of facecut veneer. More than enough for this set and my GE 810.

First, I had to patch up all the dings from my forceful top removal. I also tightened up some loose joints.


Here I've cut a new piece with a 2" overhang all round.


I'm going to use the technique I picked up from Reece of coating both surfaces with diluted wood glue and allowing to dry.


I used some clothespins to make sure it was centered over the cabinet before using an iron to re-activate the glue.


Finally, I carefully trimmed it down to size with a utility knife and small block plane.


That left patching a few damaged areas. Here's the worst one. I cut away the damage until I had a clean edge. Then rubbed over it with the side of a pencil to make a template.


I used that to cut a patch from some of the old veneer I saved from the top and glued it in place.
I brushed on a little clear shellac to seal the veneer. I'll be adding a few more layers and sanding down to fill the grain. I need to darken up that seam too.
I think it turned out well so far


Now, how to deal with that control area Then on to some toner lacquer.
__________________
Here are my Vintage Radio & TV YouTube Channel and Photo Gallery

Last edited by bandersen; 09-20-2010 at 01:02 AM. Reason: added some more pictures
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:53 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.