Quote:
Originally Posted by Don Lindsly
You can bypass the balun by connecting 75 ohm directly to the balun output-RF input. Use a series capacitor around 500-1000 uuf between the 75 ohm center and the RF input. Use another cap between coax ground and chassis ground if the TV has a hot chassis or make sure you use an isolation transformer. It's a little sloppy, but it works.
|
Tried it, no improvement.
I may try the B&k 1076 again, this time injecting the signal at at different points around the RF tube and the osc.
I got a line on a tuner from a fellow over on ARF so I will go that route.
as far as bypassing the RF/IF, yes I know it produces a better pic, but I just dont like doing that. Of course I may change my mind after I run out of ideas/options on what to do to fix it.