Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Antique Radio

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #22  
Old 07-29-2010, 07:20 AM
Reece's Avatar
Reece Reece is offline
VideoKarma Member
 
Join Date: Jul 2004
Location: Cleona, PA
Posts: 2,178
When this radio was built, voltages were probably listed as tested with an analog multimeter. Today, line voltage is higher, and the meter you are using is more sensitive and loads the circuit less, so you will typically read higher voltages. The voltages you listed earlier are reasonable. Are you getting 7.9 volts with all the tubes plugged in and heaters glowing? That does seem a bit high but don't think there's anything wrong with your transformer. If turns were shorted you'd get lower voltage and the xfrmr. would get toasty.

With set turned on and no tubes plugged in you will get higher heater voltage. With all tubes plugged in, the voltage should come down to close to 6.3 AC, maybe a bit higher allowing for higher line voltage. Set your meter to 200 volts AC and stick the probes in the wall socket. What's your line voltage?

Did you do the freeze test on resistors yet? No need to replace all the resistors in the set. I almost never have a bad resistor, or only one or two.
__________________
Reece

Perfection is hard to reach with a screwdriver.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:45 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.