![]() |
|
|
|
#1
|
||||
|
||||
|
I know that electronic restorations can be challenging enough, but I'm always the most impressed when I see seemingly rough cabinets made to look like new. I really like what you've done with this one, especially since it strikes me as a fairly less-common example. I also love anything with a built-in record player! I swear I've seen a grill cloth pattern close to what was in there originally but I don't recall where. Probably on grillecloth.com or radiodaze.com. I looked, but never did see the crack in the veneer.
Very nice work! It's always nice when you can say that you've actually been introduced to music by listening to an old radio such as this one. I've heard songs for the first time on my old Zenith, and when I think about it... it's rather humbling to know that the same radio was playing music for somebody decades before I was ever born! |
|
#2
|
||||
|
||||
|
hey, it looks great to me! I was just reading today about burl veneers, and how you should not use contact cement on them, but rather some other special glue-is that possible what caused it to crack?
|
|
#3
|
||||
|
||||
|
I used the "apply a thin layer glue, let it dry and iron it on method" it cracked because I was unwilling to cut past the iffy part right on the edge of the incredibly cheap veneer I bought off ebay. I knew it was iffy but in the process of gluing it down and curing it split apart. I thought I could fill it with lacquer but lacquer is about as filling as rice cakes. Also at the time I thought the project would turn out like crap so I wasn't going overboard to make it perfect. When I got some lacquer on it and started to see the improvement I changed my tune but it was too late to change/fix the veneer.
I got four 8" by 10" sheets of burl veneer for $12 so it was only natural that it wouldn't be the highest quality. I don't know if you can see it but the 45 degree angle corner joints also had a photo finish decal and I replaced those as well. Since they were only a half inch wide it presented extra problems. Last edited by Scuzzer; 07-28-2010 at 07:51 PM. |
|
#4
|
||||
|
||||
|
I've looked at both and there are some patterns that would work here. The original was so faded that I have no idea what the colors were. Behind the center rosetta there was some color left and it looked like it should be a fairly bold print. The only picture on the net of one of these radios is about as bad as my original shot so that's no help either. I figure I'll pick up something that has gold and browns in it with a heavy weave and call it done.
Last edited by Scuzzer; 07-28-2010 at 07:53 PM. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|