![]() |
|
|
|
#1
|
|||
|
|||
|
Exactly, NTE358. You need the big style, the small ones quickly fail under the high voltage.
I found some at the local electronics store that look like a big blue disc capacitor and they seem to hold up. |
|
#2
|
||||
|
||||
|
Thanks, now I know what to look for.
You're lucky to have a local store that carries components. I phoned the most likely place I could think of around here, and had to spell the word c-r-y-s-t-a-l for the clerk. Trying the crystal I salvaged from the junk board was a waste of time. Made weak color bars and a faint sound of frying bacon, so I immediately powered down. Perhaps it wasn't up to that voltage. No harm done, anyhow. My generator's a Leader LCG-396 of unknown vintage. New enough to be solid state. I have tried a few other sources, including the agile modulator that I use for in-home broadcasting, and at this stage nothing produces good color but the generator. Which could mean one of two things, I guess: [A] the generator's frequency is different than all the others, or [B] its signal is stronger. Regarding signal strength, tweaking the AGC control doesn't affect this problem. I'll keep pokin' around. Phil |
|
#3
|
||||
|
||||
|
not a new problem...
Over the years, ten percent of the operational CT-100 sets I know of have exhibited this problem. In these sets, changing the crystal has thus far been ineffective. While the gremlin(s) involved is(are) not yet fully exposed, the IF strip is suspect.
Since poor tube-socket connections can drastically change the signal level from the video detector, I speculate that same type of anomaly could cause a tilt in the IF response that could result in a loss of chroma sync. Here's what I did for the signal level problem: used a bottle of DetoxIT D100L and some nylon cleaning brushes (also gotten from Craig) to SCOUR each tube socket connector. Since the loss of OTA NTSC color, I nearly exclusively jeep the signal and bypass any IF problems. But, during the final years of NTSC, I didn't again experience the chroma sync problem. |
|
#4
|
||||
|
||||
|
I'm surprised the crystal comes in that can, since the RCAs from slightly later used the tube-envelope-with-a-crystal construction. Can't beat that awesome '54 date code, however.
|
|
#5
|
||||
|
||||
|
I'll give those tubes & sockets another good cleaning. Like a two-year old's face, there no such thing as too clean!
Perhaps something's off in the front end. It's notable that the fine tuning point for best color bars and best DVD (or whatever) image are not the same. When I switch from generator to DVD player, I don't even get a picture until I turn the fine tuner somewhat. Saying "best" tuning point for color bars sounds more precise than it is. One color or another will change as you move the fine tuner slightly, so I go for the best compromise (largest number of colors closest to ideal). Magenta is usually the hardest to get close. Perhaps there's a more scientific way to tell when the fine tuning is set to the right frequency . . . ? Phil |
| Audiokarma |
![]() |
| Thread Tools | |
| Display Modes | |
|
|