Quote:
Originally Posted by Adam
I just touched up the original finish on my VT-71 (because it wasn't really too bad to begin with) but it doesn't look nearly as nice. And I don't have a have back for either of my VT71s. I've come to the conclusion that they must have made loads of these sets, they're so common compared to other 1940s sets, but somehow the fine tuning knobs and backs still seem to be quite rare.
And I have yet to get my 7JP4 all the way into my reproduction mask, every time I get it jammed all the way in there the picture winds up being a little crooked, then I go to turn it and it comes out slightly again. Anyway, the picture on that set looks great.
|
Thanks for all the kind words guys!
If I had it to do over again, I'd try to touch up the photo finish. The rest of the cabinet is worth refinishing I think though. The veneer is incredible looking - it really shimmers in the light. I asked around some veneer suppliers and the consensus was that it's blonde mahogany of some sort.
I bet most of the fine tuning knobs fell off. There's not much holding them on and they see a lot of action.
Maybe backs were removed for better ventilation ? The cabinet gets really hot above that ballast tube. I left the old asbestos in place to protect the wood. It should be easy to reproduce a back given some
perforated sheet metal and a brake to make the 3/4" lip. Not that the lip is really necessary.
I had exactly the same experience with the mask in two sets !