![]() |
|
|
|
#1
|
||||
|
||||
|
RCA's patent on the CTC-4(X) SCR deflection circuit - explains some more, specific to Horizontal Deflection.
Cheers,
__________________
Brian USN RET 22YRS (Avionics/Cal) CET-Consumer Repair and Avionics ('88) "Capacitor Cosmetologist since '79" When fuses go to work, they quit! Last edited by Findm-Keepm; 09-29-2017 at 06:39 PM. |
|
#2
|
||||
|
||||
|
I am SO glad this set was saved....and did not end in a garbage truck!!
MIND YOU--I would have REALLY liked to be the one showing it off and such. But that was not an option. Thank goodness one of "US" has it now. And VERY good job--in getting those pictures!!! I have SOOO long wanted to see that RS-246 amp "for real"--and not just in a service manual!! It DOES INDEED look pretty beefy---with that big sink and tranny. Looks like someone has "worked on it" before though--that cap does NOT look original. And BTW--AFAIK--ALL SCR sets use that commutating coil--it is part of the scr circuit--as was discussed. I think it is in the retrace ckt. IIRC...the "trace" ckt stores energy and drives the yoke--and it is discharged in the "retrace" pulse--into the flyback and thus--HV....or something like that--it has been many years since I read much about the SCR deflection system. I know most techs HATED them--in the old days!! I personally liked the SCR setup. |
|
#3
|
||||
|
||||
|
Thank you all for the great info.
I couldn't bear the though of this set ending up in the trash either. Glad to have it...just gotta figure out where to put it. ![]() It was my feeling as well that the power supply had new(er) caps in it. There is absolutely no hum in the audio and those definitely do not appear to be factory caps. I also noted that the wiring harnesses were not in their factor clips, a further clue that the supply had been serviced. That being said, it doesn't appear that the set has had much if any other servicing. All the factory clips seem to be in tact. Pretty amazing really. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|