![]() |
|
|
|
#1
|
||||
|
||||
|
Very sorry to hear... I know how touchy those are, as I lost one that way when Dunbar rebuilt one for me. It made it all the way through the process, then imploded on the cooling rack (back in the 80s).
I haven't any duds (or any good ones for that matter)... But I'm sure you'll get some with a little patience. Charles
__________________
Collecting & restoring TVs in Los Angeles since age 10 |
|
#2
|
||||
|
||||
|
Charles,
Rate of heating and cooling is the key to successful rebuild of all crt's with a metal shell. You have to ramp up and ramp down very slowly. At Hawkeye, the oven cycle for a metal tube is 6 hours long, (as opposed to 3 hours for an all glass tube) using a very long and slow ramp up and ramp down. Then the tubes sit in the oven overnight to cool to room temperature. I suspect that Dunbar would have been succesful with your tube if he had just left it in the oven overnight to cool down instead of taking it out of the oven and puting it on the cooling rack. I read somewhere that there was a seperate cooling down oven that was used on metal tubes after they exited the old pump down production lines, in order to bring the tubes down to room temperature at a very slow rate. Bob
__________________
Vacuum tubes are used in Wisconsin to help heat your house. New Web Site under developement ME http://AntiqueTvGuy.com |
|
#3
|
||||
|
||||
|
Could be something as simple as a thermocouple gone bad in his oven too.
John |
|
#4
|
||||
|
||||
|
Nope, not a thermocouple. Scotty has two independent temperature sensors in the oven. One drives the controller and there is a second that just monitors the oven temp. Both were in agreement within about 5 degrees. So 600F was pretty much right on the mark.
__________________
Vacuum tubes are used in Wisconsin to help heat your house. New Web Site under developement ME http://AntiqueTvGuy.com |
|
#5
|
||||
|
||||
|
Re : I'm thinking 30 hour bake - out
RE : I'M THINKING 30 HOUR BAKE - OUT
__________________
honey |
| Audiokarma |
![]() |
| Thread Tools | |
| Display Modes | |
|
|