![]() |
|
|
|
#1
|
|||
|
|||
|
well I have a swimming pool, I may just go set it face down in there and let it be for a week or two, just the face of course I dont want to rust the anode or pins.
|
|
#2
|
||||
|
||||
|
a small wading pool is perfect.you dont have to fill it up all the way.enough water to submerge the safety glass only.i have used many methods.one effective was the use of wd 40 and a heat gun.spray it into a loose edge and watch it penetrate .use of the heat gun forces it to spread,loosening the glass.it speeds the progress tremendously.the hot wire,hammer and chisel,piano wire,etc.i think i have ran the gamut.the wading pool is the safest,but also the most time consuming!
|
|
#3
|
|||
|
|||
|
ok I will will do the wading pool approach and report back, no hurry since I dont need this CRT right at the moment.
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|