Repairing old 1951 sentinel 424

[Patnukem]

sorry for drifting to a completely separate question in the last post I was up to late I guess. I replaced some more resistors a lot of them are way off I think they are almost all replaced minus two in the HV cage and the sound/rf circuit since I am still receiving a signal fine and can hear it. I may start replacing them anyway. as right now I only have a very very cheap multimeter my good ones are in storage somewhere so the measurements I get may be a bit off but after replacing some more resistors the B+ seemed to drop 5-10v but still is about 385v and not 350v. I did notice that the HV filter cap had a lead that seemed a bit loose and spin a little but but very tightly. I do not have anyway to test it to see if that is causing the problem.