![]() |
|
|
|
#1
|
|||
|
|||
|
half meg? geez there must have been a super critical adj. check check the tube resisitance on pin 9 of the 6dr7 vert out tube to ground. Should be around 450 ohms, give the meter a chance to settle in as there is a bypass cap across it. It must be set to nearly fully closed (min resistance).
|
|
#2
|
|||
|
|||
|
C3 that bypasses it will most likely be open, it sets next to the Pwr tranny and gets baked, dries out, at least that was the case on two predictas I worked on.
|
|
#3
|
||||
|
||||
|
I'm not sure I understand you. I see C3 as a ceramic cap up on the video IF board. The only cap I see near the P.T. is C41, a .047 line bypass?
|
|
#4
|
|||
|
|||
|
I am looking at the SAMs, C3 section A is one of the electros that bypasses the cathode of the 6DR7. The sams and the notes printed on the PC board do not match up. See if you can find a wire from the thin can (low volt 100mfd) going to the pin 9 of the 6DR7 (or to the pot that connects to that pin).
|
|
#5
|
||||
|
||||
|
Quote:
|
| Audiokarma |
|
#6
|
||||
|
||||
|
Quote:
|
|
#7
|
|||
|
|||
|
interesting, that pin is supposed to be connected to the pot, so I assumed it should have done something. See if you can trace the pot to a tube pin.
|
|
#8
|
||||
|
||||
|
Quote:
I traced the pot to a wire connected a lead for the 400v B+ that jumps over to the that same e-can, hooked to the 10 mfd 450v? |
|
#9
|
|||
|
|||
|
hmmm, maybe some kind of rigged up focus control. need more can you tell where each lead goes and I will see if I can find out whats going on. the Lin pot is a cathode bias pot, pin 9 to ground.
|
|
#10
|
||||
|
||||
|
Quote:
Huh? Tone control, maybe? I thought this might be an audio pot, at least it is similar to tone control pots I've seen in old tube amps. I really don't know. Let me know if this picture helps, or if you need me to take some other detailed shots.
|
| Audiokarma |
![]() |
| Thread Tools | |
| Display Modes | |
|
|