![]() |
|
|
|
#1
|
||||
|
||||
|
Without a manual channel selector knob anywhere on the set, how did one change channels if the remote got lost, broken, the motor drive went bad, or the remote's batteries went dead?
Seems like a very poor way to design a TV power tuning system; after all, most TVs with power tuning and remote had a manual channel selector on the back of the set, to be used in case anything went wrong with the drive system or the remote hand unit itself.
__________________
Jeff, WB8NHV Collecting, restoring and enjoying vintage Zenith radios since 2002 Zenith. Gone, but not forgotten. |
|
#2
|
||||
|
||||
|
Quote:
If the motor drive went bad, neither remote or front controls would do much good. It's a varactor design, so manual means are exactly what RCA was "designing out" of the set. It's the precursor of todays sets with no manual means other than tactile buttons on the set and remote. Cheers,
__________________
Brian USN RET 22YRS (Avionics/Cal) CET-Consumer Repair and Avionics ('88) "Capacitor Cosmetologist since '79" When fuses go to work, they quit! |
|
#3
|
||||
|
||||
|
Thanks Findm! At least now I've got the part number for the inserts. I'll see if Moyer has it. The tabs are thick and heavy enough (and have a rather critical shape) that making your own set wouldn't be all that simple.
By the way, it doesn't appear to matter whether there's a signal or not on the selected channels. The channel selector only goes in one direction, but the drum rotates *very* quickly, and does not pause or hesitate at all on 'skipped' channels. As Findm says, the up/down volume buttons also control the power. If the set is off, pressing "volume up" (on either the remote or the front panel) switches the set on. Turning down the volume past the 'zero' point switches the set off. As such, it functions much like a 'digital' version of the traditional combined off-on-volume analog control knob. Incidently, the power/volume controls on this set appear to be fully solid-state-- I don't hear any motors or relays when operating the up/down volume buttons. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|