![]() |
|
|
|
#1
|
||||
|
||||
|
You can see the Chicago TY-1 here: http://www.bunkerofdoom.com/xfm/CHICAGO1954/004.jpg
and the similarity to the Sylvania 100-0002 is very strong. The data is here: http://www.bunkerofdoom.com/xfm/CHICAGO1954/003.jpg and the TY-1 is not cosine wound. It has an iron wire core just like the Sylvania. Not too surprising that focus was so touchy. Especially if they stretched the design to go from 53 degrees to 70 degrees. John |
|
#2
|
||||
|
||||
|
I moved the balancing capacitor from its original position to the hot side of the yoke. I didn't take any before pictures because the ringing was so severe I was afraid it might damage something.
I haven't aligned the horizontal section or do any serious adjustment of the vertical. I was mainly interested in seeing whether the ringing would be reduced and if the focus would be good. The focus looks good, there is still a little bit of ringing. The balancing cap in the original yoke was 47pf and the one in the RAM replacement is 68pf. I'll probably use a variable cap first to see what value works best. Then I need to shim the yoke. For some reason it tilts down a little when it's mounted in the saddle. Then I'll align the horizontal. That will take care of the curvature and reduce the flagging. There was always some flagging unless I was receiving an over the air broadcast. No chance of that now. There may be a minor problem in the sync separator. John |
|
#3
|
||||
|
||||
|
Looking good!
![]() ![]() ![]() ![]() Wow! That was a long uphill battle, but it really shows that persistence does pay off! ![]() jr |
![]() |
| Thread Tools | |
| Display Modes | |
|
|