Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
Reply
 
Thread Tools Display Modes
  #1  
Old 02-25-2010, 10:29 PM
bandersen's Avatar
bandersen bandersen is offline
RCA 741PCS
 
Join Date: Mar 2009
Location: Chicago, IL
Posts: 8,829
Hi dawgs,

I hope you're feeling better. Sometimes unused tube pins were used for tie points for components. That might explain your cap on pin 1. I'd replace all the caps in the audio section and check the resistors if you haven't already. Then I'd power the set up and test the voltages - in particular pin 3 & 4 on the 6W6. They should be 255v and 260v respectively. Check the 3.2 ohm speaker coil too and 6W6 if you have a tube tester. Worst case scenario you've got a bad audio xfrmr. Try to eliminate everything else first though. It might me a little tough to track down a replacement but we'll deal with that only if we need to.

Bob
__________________
Here are my Vintage Radio & TV YouTube Channel and Photo Gallery
Reply With Quote
  #2  
Old 02-26-2010, 08:22 AM
dawgs's Avatar
dawgs dawgs is offline
VideoKarma Member
 
Join Date: Feb 2010
Location: the cold country
Posts: 27
thanx for the reply

thanx bandersen for the reply, I'm not all that smart when it comes to tube radios or t.v.s, for me, it's sort of hit & miss., more miss then hit. bandersen, may I ask you an couple of more qwuestions?. is it possible to run the chassis part of the set out/side and with the c.r.t., yoke & the h.v. frome the picture tube un-hooked,. and can I use a audio out/put xformer frome a tube radio with the same color code on the input & output of the tube radio xformer leads?.



thanx again to you and every-body on this site.


dawgs
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:09 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.