![]() |
|
|
|
#1
|
||||
|
||||
|
If you rotate the yoke 90 or 180 degrees does the area of poor focus follow the mechanical rotation of the yoke? If it still stays on the right hand side of the tube, perhaps some steel part near the neck of the CRT is magnetized ?
jr |
|
#2
|
||||
|
||||
|
I can probably only rotate the yoke over a +/-15degree angle. But that's probably enough to do the test you suggest.
I don't think it's a magnetized part of the chassis. The point at which the focus gets bad follows a vertical line. I wouldn't expect it to follow a straight line line if it's the chassis. It's a good test though, if the bad focus rotates too, then it has to be the yoke. John |
|
#3
|
||||
|
||||
|
I have a Sylvania yoke that is similar to the one in the set. I just did a ring test on it and got 25 rings. Quite a bit more than the one in the set.
Sencore says to make a shorted copper loop and place it around the yoke windings. If the number of rings doesn't change by a lot, then there is probably a shorted turn. I'll have to try that along with rotating the yoke over its limits. But, not tonight... John |
|
#4
|
||||
|
||||
|
I finally scored a hit with Moyer's. They have a RAM yoke that will replace either the 100-0001 or 100-0002 Sylvania yoke. I don't think that there are many of these around so it won't hurt to have one on hand even if it turns out that the yoke is o.k.
John |
![]() |
| Thread Tools | |
| Display Modes | |
|
|