Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #20  
Old 02-22-2010, 01:32 PM
Findm-Keepm's Avatar
Findm-Keepm Findm-Keepm is offline
Followin' the Rules...
 
Join Date: Jun 2007
Posts: 2,857
I have two of these variable VHF-only attenuators, one Blonder Tongue and one Channel Master. Both are very similar in construction - the BT has a 220 ohm resistor across both the input and output, with a 1K pot between the input terminal and the output terminal. The writing is worn off the case, so no model or attenuation factor.

The Channel Master has 240 ohm resistors (1/2w film types) and a 1.2K pot between the input/output terminals. It is obviously Asian made - there was an earlier model with a slide pot, but mine has the rotary pot. It's a carbon or cermet element. I had to desolder the shield to get to the guts - not service friendly.

Down East Microwave has the schematic to follow, about half way down this page:

www.downeastmicrowave.com/journal.htm

Just make sure it's in a shielded encosure. Hammond and Pomoma make nice little boxes for this kind of use.

Cheers,
__________________
Brian
USN RET 22YRS (Avionics/Cal)
CET-Consumer Repair and Avionics ('88)
"Capacitor Cosmetologist since '79"

When fuses go to work, they quit!

Last edited by Findm-Keepm; 02-22-2010 at 01:34 PM. Reason: hammond spelling
Reply With Quote
Audiokarma
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:55 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.