Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Rectangular Screen Tube Televisions

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #3  
Old 02-22-2010, 01:20 PM
Zenith26kc20's Avatar
Zenith26kc20 Zenith26kc20 is offline
VideoKarma Member
 
Join Date: Apr 2009
Location: New Orleans
Posts: 860
The magnets that were glued to the bell of the tube are additional purity magnets. They were installed at the factory. If you have them, after fixing the degaussing circuit, try placing them (one at a time) back where they were. It takes a bit of patience (and turning the air blue) to get them right.
I have used the two lead degauss themistor in place of the three lead. You have to find which two leads are AC. The third lead on Sony TV's go to AC neutral (most of them) and it gets the degauss out of the circuit quicker by heating it quicker. They do, as mentioned earlier, have problems with solder connections.
You may want to check the vertical IC on this set as it is prone also to bad connections underneath. If you have a ESR meter, check caps in vertical and in tuner power supply as well as standby and relay drive. They dry up and lose capacitance, blowing the vertical IC or making the set go nuts.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:37 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.