|
found a 33k resistor in the bass tone circuit that had drifted off to over 100k and since the bad side has no attenuation in the tone circuits i will start there.
I am feeding a audio sine wave into the tape input and then tracing with the scope comparing L and R (they are both getting audio feed thru two coupling caps to the same source). I could see a change in amplitude at one point which then I checked with the meter to find the bad resistor. Its kind of a pain since its a pcb with resistor up on end, so you have to measusre from the foil side and look at the top side to see the color bands.
hope this is it...
|