Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Rectangular Screen Tube Televisions

Notices

We appreciate your help

in keeping this site going.
Reply
 
Thread Tools Display Modes
  #1  
Old 02-02-2010, 06:08 PM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
there is a very brief surge thru the degausser. I wonder if I could use the built in ring and a varic to directly run the ring for a short peiod of time.

energize it, the ramp down the voltage slowiy, with the variac hooked directly to the unpluged degauser that is.
Reply With Quote
  #2  
Old 02-03-2010, 12:09 AM
zenith2134's Avatar
zenith2134 zenith2134 is offline
VideoKarma Member
 
Join Date: Feb 2005
Location: UTC -4
Posts: 2,546
Haha, yeah I know 8track was mediocre
Reply With Quote
  #3  
Old 02-03-2010, 12:23 AM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
darn stereo is turning into a tough dog...

one channel is fine, the other is some how bypassing the loudness/tone controls, you have to keep it turned almost all the way down on the balance pot to make it work.

I am 99% sure its not an open pot, but rather a decoupling issue. I had a problem like this a while ago, but I have done my normal checks of the audio decoupling caps and they test find and jumping them did not improve. I may have to did out the scope and see if I can see where the signal is getting in.

Argh... the TV was a push over and the dumb radio turns into a tough dog.
Reply With Quote
  #4  
Old 02-03-2010, 01:11 AM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
I give for now, def need the scope to see where this darn audio signal is coming from....
Reply With Quote
  #5  
Old 02-03-2010, 06:20 PM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
found a 33k resistor in the bass tone circuit that had drifted off to over 100k and since the bad side has no attenuation in the tone circuits i will start there.

I am feeding a audio sine wave into the tape input and then tracing with the scope comparing L and R (they are both getting audio feed thru two coupling caps to the same source). I could see a change in amplitude at one point which then I checked with the meter to find the bad resistor. Its kind of a pain since its a pcb with resistor up on end, so you have to measusre from the foil side and look at the top side to see the color bands.

hope this is it...
Reply With Quote
Audiokarma
  #6  
Old 02-03-2010, 06:44 PM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
Ok, here is the deal, the resistor was ok (I was reading the wrong pad, again due to the upward mount of the resistor), but I got it fixed!

Very odd, It seemed like the signal was working upto a resistor, no signal on the side that comes from the pot, but signal on the side that goes to the amp, odd. I disconnect the jumper wire that connect the amp to the output of the loudness pot. no signal now (I have the pot turn all the way down, and signal was still getting amplified). hmmm I check the amp side no signal there either, hmmmm. I resolder the jumper and bingo its working fine now.

I have no idea what was going on, why the amp was getting signal with the loudness turned all the way down, but its ok now (I think, I am going to hook up and try again. very odd).
Reply With Quote
  #7  
Old 02-03-2010, 06:50 PM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
working perfect, man that was strange...

Now all I have to do is reinstall the stereo. There is no aux button like I thought. I may see if I can install a DPDT and put in a couple RCA inputs so I can choose between the Tape and the inputs of the TV.

Or maybe even get creative and do a DPDT relay that when off goes to the RCA for the TV tuner input and when on goes to the 8 track, then power it off the same power as the TV (maybe a pilot lite take off). That way when you turn on the TV the relay switches off tape and on to TV.
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:17 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.