![]() |
|
|
|
#1
|
|||
|
|||
|
Those are good ideas for rust. And the usual dust.
But what about sticky crud? Like sticky crud with sawdust, dust bunnies and lord knows what else? (no mouse droppings or it would be in the trash!) I'm thinking of a spray solvent is needed. But don't want to disolve the working components! The radio works after a couple electrolytics and re-soldering a dozen bad solder joints. Just still nasty inside. Must have been in a kitchen for a long time. The outside got cleaned but not the inside. |
|
#2
|
|||
|
|||
|
Terry,
The philco looks great! Good transformation. I often restuff cardboard multi-sections and cans just because sometimes it's easier than figuring out a different mounting system. I don't mind someone seeing orange drops or yellow drips when they open up a set. I have thought about stuffing and re-waxing those old wax paper caps though. |
|
#3
|
|||
|
|||
|
Well I've used things like Kerosene, really stinky WD-40, Mek, odorless mineral spirits, white gas, alcohol. All should be used with care as they are combustible. I like petroleum distillates most evaporate quick and are strong. Good for cleaning wax dripping. Sometimes a heatgun is a good tool to get off sticky drips and other stuff.
Terry |
|
#4
|
|||
|
|||
|
Maybe kerosene and a match???
I'm thinking you are right about some kind petroleum distillates. Something more refined like alcohol that evaporates quickly. Will have to test certain areas ahead of time in case it would turn the thing into a mass of goo. Thanks! |
|
#5
|
|||
|
|||
|
If you could post some pic's it would be helpful.
Terry |
| Audiokarma |
|
#6
|
|||
|
|||
|
I'll try to snap some tonight.
Where is Roslyn PA? I grew up, went to elementary and jr/sr high school in Concordville (near Media) PA. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|