Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #15  
Old 09-29-2009, 09:01 PM
Eric H's Avatar
Eric H Eric H is offline
Administrator
 
Join Date: Jun 2002
Location: So. Calif
Posts: 11,565
According to your schematic 156 and 157 are in one can, that would be the two section one shown on the right side of your first picture, those are 40 & 80 MFD @ 350v
You can use a 450 volt capacitor in place of a 350 but they are bigger and that can cause a problem when you are restuffing.

Right next to the lugs on the bottom is a logo, a half circle for the 40 and a triangle for the 80, you can see those on the schematic, also the values should be stamped in the paper sleeve of the capacitor.

The twisted lugs are the ground (negative) for the capacitor, however in that case the Cap ground is not the same as the chassis ground, that's why they are mounted in a Phenolic washer, matters not as long as you connect the - terminal of your new cap to the ground lug and the + to the lugs in the center.
Reply With Quote
Audiokarma
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:41 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.