Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Antique Radio

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #4  
Old 07-07-2009, 02:15 PM
Reece's Avatar
Reece Reece is offline
VideoKarma Member
 
Join Date: Jul 2004
Location: Cleona, PA
Posts: 2,178
You were on the right track to install a phono jack. The manufacturer would have installed a switch to select between radio and phono, but you could get around that by using a closed-circuit 1/8" miniature phone jack as in the circuit below. For radio operation, the detected signal comes to the jack on the green wire and then to the volume control on the red one. When an external audio source is plugged into the jack, the jack opens the green radio circuit and sends the audio signal via the red wire to the volume control.

Back in the day, nobody bothered about making the phono connection idiot-proof and so on AC/DC sets the shield connection of the jack could have been connected to chassis ground as shown and therefore "hot" depending on which way the power plug was in the receptacle. Today you'd want to put an .05 or so mfd. cap between the shield connection of the jack and chassis ground, the jack being insulated from the radio chassis in some way. I'd also run audio wiring like this in shielded cable under the chassis, grounding the shields.

Reece

__________________
Reece

Perfection is hard to reach with a screwdriver.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:18 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.