![]() |
|
|
|
#1
|
||||
|
||||
|
You may have a poor contact at one of the plate pins. Or (less likely but possible)
the cathode in one of the halves of the tube may have been damaged by excess current, while the filament did not open. Do the two halves of the filament (visible at the top of the plates) look the same color when the tube is heated in the tester? Good luck. |
|
#2
|
||||
|
||||
|
Yes, both filaments look the same when lit. I will check the socket on the tester, too. I just wondered if it was normal for half of the tube to be bad and what were the odds of both 80 tubes reading the same way. It made me start thinking it may be the tester. Thanks for the reply
|
|
#3
|
||||
|
||||
|
Have you done any restoration on the tester? Vintage testers require routine restoration (including calibration), just like vintage radios.
Phil Nelson |
![]() |
| Thread Tools | |
| Display Modes | |
|
|