![]() |
|
|
|
#1
|
||||
|
||||
|
Nice! I'll pretty much take any set with an ultrasonic remote.
![]() Funny that I saw this when I signed in today....I was away for a couple of days and found a May, 1977 Sharp 12" B&W....took it just for laughs. Its on the side of my house awaiting trash collection. But I have to agree with you, that Sharp products weren't half bad in the mid-late-70s (at least still made in Japan). |
|
#2
|
||||
|
||||
|
Quote:
By the late '80's, Sharp started going to the dogs big time. They may have been OK if it wasn't for bad soldering and lousy cabinets that became brittle and fell apart. I recently trashed a late '90's Sharp 25" in a trash bag, literally. The cabinet had become brittle and would shatter if you touched it. |
|
#3
|
||||
|
||||
|
This one's got a bad horizontal hold coil, of all things. I took it apart and one of the leads was charred and had disconnected from the board. But yeah, it's a single PC board chassis, crummy tuners and very crummy cabinet. The CRT is a Toshiba branded Sharp (which says, "do not use ion trap!") and the HOT is a Hitachi to-3 package.
I'd save it but it has other problems. When I resoldered the windings on the coil it came on with reduced width and a snowy raster. Bet the flyback is indeed about to go up in smoke. I had 2 other Sharps that I can remember...both for free... an '87 knob tuned 13" and an '86 knob tuned 19"... same type of sets, flimsy cabinets, cheap controls, and single-board, boring internals. They make a halfway decent picture when working but they were crap IMO. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|