![]() |
|
#11
|
|||
|
|||
|
Unless I missed something, everyone in this discussion has only talked about Zenith CRT problems around 1992-'93. By 1990 I was seeing Zenith tubes fail faster than I could haul the carcasses away, starting with sets from '87 and '88. Lots of H-K shorts, and lousy emission.
RE: CTC120-136 chassis. I got in the habit of resoldering those wire wrap stakes on every one of those sets, no matter what I was asked to fix. Kept the callbacks down to near zero. Re: CTC175+ tuner-on-board: I hated it because it was a stupid design, not having wires to backup those tabs on the shield to tie grounds together, AND I loved it because I have earned tens of thousands of dollars fixing them. At one time I had a running count going on how many I had fixed. I lost track at almost 600 units, but I was still fixing those then so the total is higher than that. ( I still see one from time to time) At the Thomson training session that covered those (spring of '93 I think) several of us went to the FSM and expressed our concern about that design during the lunch break. We were assured that the engineering guys had tested the design and the grounds would not fail as they had been doing in Zenith and other tuners. AS he said that , I had the feeling that he didn't really believe it, but he had to say it. Plastic camshafts in lawnmowers??!!! I was not aware of that, but it sure explains a lot! I have seen plastic pistons in brake calipers. Wont use them again. I've had 2 of them warp and bind in the bore. Sure made the van steer funny! Re: Sony blanking until the tube is warmed up. I recall Sony did issue a mod for those sets to reduce the blanking sensitivity. I think late production sets came with it from the factory but early models were extra touchy and changing a resistor or two helped. OK. I'm done now. |
| Thread Tools | |
| Display Modes | |
|
|