![]() |
|
#4
|
||||
|
||||
|
Quote:
As I understand it, ballast tubes were the predecessors of resistance line cords and, later, wirewound filament dropping resistors. Ballast tubes were also used in early television power supplies, as I read in an old TV service book years ago; many a house fire was started when a ballast failed and the set owner carelessly jumpered across the defective tube. This may have gotten the TV or radio working again, but such a dodge can and often did result in serious damage to the unit or even the house wiring. Case in point: There was an incident back in the 1960s in Cincinnati, Ohio, where a homeowner, tired of replacing fuses when his wife's kitchen appliances kept blowing them, finally went down to the fuse box and placed a copper penny behind the defective fuse. This restored the electricity, all right, but it also removed the protection the fuse afforded the line, eventually overloading the house wiring and starting a costly fire behind the walls. Today's electric service panels, with their bolted-in circuit breakers, are incorruptible, since there is no way a homeowner can bypass them; all he or she can do is flip the breaker back to its on position when it trips--after removing the short or overload, of course. The AC power cord looks as if it is frayed at the point where it enters the chassis. I'd replace it before doing too much more with the radio. Also, it looks to me as if there may be a quartz crystal (possibly a small FT-243) in front of the antenna coil -- strange for a broadcast/SW radio of this vintage, but if it's a homebrew unit just about anything is possible. That component could even be a capacitor. It's difficult to tell, even after enlarging the thumbnail.
__________________
Jeff, WB8NHV Collecting, restoring and enjoying vintage Zenith radios since 2002 Zenith. Gone, but not forgotten. |
| Thread Tools | |
| Display Modes | |
|
|