|
Agree with all above suggestions to check. Either the cap, the tube, or the tube socket is at fault. Sometimes there may be internal charring between layers of a tube socket that short out a terminal. Pull the tube and check with your ohmmeter to see if pin 6 is shorted to any other pin: should not be. If cap is OK, unsolder the wire(s) from pin 6 and check ohms between that and all other pins and to ground. Should have infinite ohms.
Reece
__________________
Reece
Perfection is hard to reach with a screwdriver.
|
12-30-2008, 01:56 PM
Threaded Mode