Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
Reply
 
Thread Tools Display Modes
  #1  
Old 12-12-2008, 09:15 PM
Eric H's Avatar
Eric H Eric H is offline
Administrator
 
Join Date: Jun 2002
Location: So. Calif
Posts: 11,565
Hi Robert, While I can't promise what will happen if you do this I have put the chassis in the bathtub, sprayed it with some Simple Green or similar, brushed it clean and rinsed with warm water, I avoid power transformers where possible, especially if they have openings where water could get in and stick around.

I let it dry for a couple days and have even put the chassis in the oven on a low setting like 150 degrees for 30 minutes or so to drive out the wetness.

A solid state set probably has plastic i.f. coils and epoxy sealed capacitors and transformers and will withstand this better than an old set that has lot of paper parts.

I had a 70's solid state Zenith I took a garden hose to once as an experiment, let it dry in the hot Calif sun for a couple days and it still worked fine.

Dishwasher no, too harsh and the detergent is pretty corrosive plus you have no control over the process.

Of course as always you do this at your own risk! Oh and be sure it's unplugged when you do this.
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:19 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.