|
Okay, without a schematic at least verify where the wiring originates from and a tube manual may be handy. It's possible that the screen grid voltage comes from a tap on the primary side hence the three wires? A 6V6 plate/pin 3, screen grid-G2/pin 4.
There is some standardization as to color codes on transformer wiring but only use as a guide and verify. A red would be B+, blue is output tube plate, and not sure for screen grid offhand...primary side speaking of course! Output side since it mounts to the speaker are maybe just short, bare stubs that hooked directly to the speaker terminals right in line with each other.If there was any length to those wires proper hookup would be a green to the dot or positive phase of the speaker and a black lead to the other.
For those of you interested on how to check for speaker phasing all you need is a 9 volt battery preferably one that is a little low on voltage. Just go across the terminals and observe movement. Forward (outward) throw- positive/proper phasing...rearward- negative!
|