Quote:
Originally Posted by radiotvnut
I think the switch needs to be there at all times. Try the set with the switch turned off and see if any changes are noted.
Just because that board is new does not mean it does not have a fault. Most of these modules are actually rebuilt and I've had several zenith modules that were duds right out of the box, especially on the '80's and '90's sets. Also, try lightly tapping on the CRT neck with some sort of insulated tool. If the picture goes crazy, it's probably either a shorted CRT or something loose on the video driver module.
|
I have tested the CRT with a tester and it is good. I did the neck tapping and there was no change.
I do plan on making this set a project in the near future. There are a number of components that caught my eye. There a large silver capacitor with two male screw terminals attached to the bottom of the chassis I'd like to test, etc. I've already replaced the tripler and video output board. Any other components I should be concerned with? I remember reading something about an orange capacitor?
I just wish that here in L.A. people wouldn't toss out everything on a regular basis. I have been looking for a nice console model, but haven't been able to find one. I really want the white chromacolor console. It's noted in my SM as J2540X. If not that one, then a nice wood cabinet unit.
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL
Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650
|