|
Yes, and I've also known those switches not to make good contact. Spray some Deoxit or other good control cleaner in the switch and flip it a few times to work the cleaner in. If that does not work, check the B+ going to the remote sensor. I think there's three wires going to the sensor: B+, ground, and signal. If you're not getting B+ to the sensor, you'll need to trace the circuit back to see where the voltage is missing. If the B+ is there, the problem is likely in the remote receiver assembly.
I've worked on a lot of TV's over the past 20 years and I've seen very few with bad remote sensors. That switch will probably solve your problem. Even if it is the sensor, it should not be too hard to find one for that era Zenith. And, yes, those membrane keypads do give trouble. It would be best to fix the remote problem and leave the keypad alone.
|