![]() |
|
#28
|
||||
|
||||
|
the rings are for purity.it must be set first.use a red only screen for this adjustment.the 3 controls on the crt neck are for center convergance only.the smaller controls are for top.bottom,left side,right side.etc.steps are as follows-
1.-red screen -purity 2.gray scale-service line,adjust rgb to a white line,even luminance. 3.center convergance-red and green,blue vertical and horizontal(dial on purity assembly) 4.top -small controls-marked-red,green,blue 5. bottom-same 6.left side-same 7.right side-same once purity is set and center is aligned,it should be close enough for viewing.no reason why a delta gun cant be near perfect with some tweaking.dont drive yourself insane trying get it perfect-not going to happen.it can be very close and deliver a fine picture. use an alignment tool(diddle stick) for the sides.i have an xl100 from 1974 and it came out very well. good luck! |
| Thread Tools | |
| Display Modes | |
|
|