![]() |
|
|
|
#1
|
||||
|
||||
|
"BC" is a hum bucking coil. I've seen the primary resistance of these transformers read from several hundred to around a thousand ohms. The secondary will generally read less than 1 ohm. I believe www.tubesandmore.com sells a universal output transformer designed for these old radios. Usually, these transformers will simply open up on their own. Just to be safe, I'd replace any caps in the audio circuit and I'd make sure the output tubes were not shorted. If in doubt, replace the tubes.
|
|
#2
|
||||
|
||||
|
Right on with the posted response. Replace all the tubular capacitors and electrolytics if they haven't been done recently.
In order to get a decent bass response back in those days manufacturers would sometimes use some rather light-gauge magnet wire for OPT primaries, meaning frequent failure of same. It's a single-ended output stage by the looks of things, and probably not too critical. While some output transformers may provide better performance in that application than others, just about any OPT cadged from a garden-variety receiver should do the trick in getting that old radio to play. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|