![]() |
|
#24
|
||||
|
||||
|
Your voltage is probably OK as you have the rectifier out and no load on the transformer. Should drop some when the rectifier is finally working and feeding B+.
For dial cord you can use woven fishing line, readily available everywhere. If you have any missing cord tension springs, you can get a plastic box of assorted small springs from a home center like Lowe's. Somebody has been in there before you so you want to check it out carefully. When I recap a larger set like this, I like to print out a copy of the schematic, and then trace every wire in the set one by one and mark it off with a highlighter as I go, replacing caps. When the schematic is completely highlighted, you're done. It's too easy to get lost and keep going back over the same ground without a "road map." Tom is right on that 6X5. Belt and suspenders: I'd put both a line fuse and one in the cathode circuit of the 6X5 so if it shorts it won't take your transformer with it. Good luck with it, Reece
__________________
Reece Perfection is hard to reach with a screwdriver. |
| Thread Tools | |
| Display Modes | |
|
|