![]() |
![]() |
|
|
Thread Tools | Display Modes |
|
|
|
#1
|
||||
|
||||
|
In an intercarrier TV, an FM audio signal without the video carrier cannot
be received, because the operation of the circuits relies on the video carrier as a local oscillator to move the FM signal to the audio Intermediate Frequency of 4.5 MHz. I believe every FM/TV combo uses completely different RF/IF circuits for these two functions, at least after the mid-fifties. |
|
#2
|
||||
|
||||
|
Also realize that the FM deviation of broadcast FM radio is much more than that used for the sound on analog TV. About twice or 3 times.
Oh, one could rig up the front end of an FM radio tuner (front end, local osc and RF amp module) to produce 4.5MHz IF instead of the usual 10.7MHz IF. But you could get problems with images of FM stations 9Mhz away. And also, most manufacturers want to build stuff as large modules. Console TV radio sets were not made in high volume. So the easiest and ultimately cheapest way to build consoles is to use the entire chassis and CRT of the same TV they are making many of, and also use the chassis of AM/FM/phono sets they may also be making, or procure from another maker who does make many of them. Or use say the front ends and IF strips of higher end hot chassis table radios that they are making many of, and tap some B+ and share the audio output stage of the TV chassis, and appropriate switching. But that starts to get to be an engineering effort.
__________________
|
|
#3
|
||||
|
||||
|
Quote:
(*) er, I suppose that should be in the past-tense now, since the analog cellular system is being phased out, so there's probably nothing to pick up these days. You and wa2ise do bring up a very good point that manufacturers would probably have just used a regular radio chassis anyway, simply because they already have a production line for them and it'd be easier just to connect it up to a regular pre-existing TV chassis. Incidently, my RCA 8TS30, which has separate sound IFs (not intercarrier), picks up FM radio broadcast stations *really* strongly on channel 1 -- I figure it's picking up a harmonic, since doubling the frequency band used by the old channel 1 would put you right in the FM broadcast band. I've wondered if that's actually one of the reasons why channel 1 was so quickly taken away from TV use. |
|
#4
|
||||
|
||||
|
Quote:
higher UHF channels. Maybe the interference from some other transmitter approximately 4.5 MHz away was acting as the LO, but I'm not sure. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|