Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Rectangular Screen Tube Televisions

Notices

We appreciate your help

in keeping this site going.
Reply
 
Thread Tools Display Modes
  #1  
Old 05-05-2008, 11:43 AM
Tugboat Tugboat is offline
Banned
 
Join Date: Apr 2008
Posts: 40
This unit didn't have many sockets, but for $25 shipped, it's worth the risk.

I'm searching the net for copies of the manual and setup chart, but not having much luck. I might need to ask for assistance to make sure I'm doing things correctly.

If I can get this guy to drop it in the mail today, I can have it by wed or thu (priority from IA). If the output board arrives, I'm going to hang onto it until I can test the CRT. So sense risking the board if the tube is toast.
Reply With Quote
  #2  
Old 05-07-2008, 05:24 PM
Tugboat Tugboat is offline
Banned
 
Join Date: Apr 2008
Posts: 40
Okay, got the CRT tester today and I downloaded the general instructions for it from B&K. The CRT tested fine and installing the new video output board brought the set back to life.

I have the service manual (PDF) for the set, but it sure doesn't make things easier. It figured out that U8 mentioned in the manual was a connection on the sync. A.C.G. board and that when it's grounded, the show goes away and I can then set the brightness limiter and range controls. I was also able to set the G2 control to produce a dim raster. But that's as far as I was able to go/figure out.

The set produces a decent color picture with just the G2 set. The red, green and blue controls on the board are at their minimum settings. What am I supposed to do with these adjusters? I must need to do something with them or why else would they be there.

My brother says there should be a "setup" switch, jumper or something like that. The manual keeps referring to G2 and color controls...turning down all, then turning one up to get a raster of that color gun in the center of the screen and check for it being uniformed across the screen, blah, blah, blah. When I turn one of the color controls, the snow on the screen starts to take on that color. The manual doesn't say I should ground U8 for this adjustment, so how do I get rid of the snow and get to the raster?

Don't mean to babble so much, but I'm a bit confused at the moment.

Thanks!
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:13 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.