Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #7  
Old 04-24-2008, 10:33 PM
bgadow's Avatar
bgadow bgadow is offline
VideoKarma Member
 
Join Date: Oct 2003
Location: Federalsburg, MD
Posts: 5,865
The most common area to have problems on most any old tv will be the verticle circuit. Everything has to function just right to have a full and correct raster. You can be certain you have a bad cap right now. If you just want to play around, and not do the wholesale recap just yet, find the vertical circuit and seek out the caps, then replace them one by one until the problem goes away. The first old set I brought back to life was a '50 Philco and I had little in the way of experience, plus no schematic. So, I turned the chassis over, noted the location of the vert. osc, then followed wired from the vert. hold and lin controls, and looked at what was there. I found a number of caps. With each replacement I saw the picture improve. This is one way to learn as you do it.

Lots of shops have done the "leave in circuit" shortcut. Maybe some of them don't know better. Best, I think, to install a terminal strip near the base of the can and then just transfer everything over.
__________________
Bryan
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:08 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.