![]() |
|
|
|
#1
|
|||
|
|||
|
Here's a product (Slip-Plate) that fills the bill and the price is right. The last can I bought, 12 oz. aerosol, cost $6.28 - purchased two years ago, at W. W. Grainger (Grainger's) in South San Francisco. They have 425 branches in the U.S. so there should be one near you.
The basic ingredient is graphite in acetone and petroleum solvents. This is from the label: "Graphite is electrically conductive and may cause short circuits or other electrical malfunctions." Perfect! I've heard that the bulk of the customers for this product are farmers who spray it on surfaces that typically gum up on harvesting equipment. With careful removal of the old dag and appropriate masking of your tube and careful application it will come out looking factory fresh. I use a paper towel cardboard over the neck and cut a nice circle of Contact paper over the anode socket to closely duplicate the original dag coverage. Roger |
|
#2
|
|||
|
|||
|
BTW, the Slip-Plate can describes the finish color as "dark gray." Trust me, it's the same color as the finish they put on at the tube factory.
Roger |
|
#3
|
||||
|
||||
|
Interesting! Is that really a paint-like product in that it will adhere to surfaces without rubbing off easily? The graphite sprays that I've seen are basically powdered graphite suspended in a 'carrier' solution that evaporates. ...Which is great for lubricating small mechanisms, but if you were to just spray it on a large flat surface like the outside of a CRT, the graphite would probably rub off at the slightest touch, and end up everywhere.
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|