Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #33  
Old 03-21-2008, 03:21 PM
dreyfoos dreyfoos is offline
VideoKarma Member
 
Join Date: Mar 2005
Location: Castro Valley, CA
Posts: 64
Progress? report:

First, a puzzling observation: the 100 ohm focus coil shunt (Sam’s R127, Rider’s R65) seems, at this time, to be superfluous. No difference in the raster focus whether it’s in or out of the circuit. I subbed all the way down to 0 ohms and up to several hundred with no effect on focus. I know manufacturers aren’t in the habit of spending extra pennies for nothing. Seems significant to me – could this be the missing piece of the puzzle?

It was noticed as I was inch-worming my way through the circuitry to verify every connection and component. I have found nothing out of place so far. All electrolytics are fresh and polarity double-checked.

I also rigged up for smoother DC from my breadboard supply to the focus coil. I used two 22uF 350V’s with the secondary of a filament xmfr in between as the inductor. There’s still a ripple but it’s much reduced – appears as one or two bands instead of six or eight.

It took 30 VDC indicated on my Variac and confirmed with the VTVM to get perfecto focus using the lower ripple breadboard supply. The current measured 195mA with the digital ammeter. This same alternate supply - without the new filtering - gave perfect focus at 160mA and 33VDC.

(I’m still trying to get an ammeter to confirm what I’m now getting with the digital. I took out the meter on my old Hickok and it seemed to be moving freely once I could hold it in my hand and subject it to gravity from different directions. Now I need to check all the shunt resistors in the range circuits and then there are the contacts and connections to clean up before I put it back together.)

Don, you said, "Try a 10-20 uf electrolytic on the 5U4 side of the B+ source when measuring total TV current drain.” I’m not clear on where I should put that cap relative to the meter. Do you mean in series with the digital meter lead?

Roger
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:10 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.