![]() |
|
|
|
#1
|
|||
|
|||
|
If it has a pot for vertical size, it would be as simple as adding a second pot and a switch to change which one is in circuit. You should try to design it so that it doesn't lose vertical deflection when when you switch it. For examplt, if lower resistance = a larger picture, then set it up so that the second pot is connected in parallel to expand the picture for full screen.
Be aware that there may be objectionable stuff visible in the VBI when the picture is compressed. Macrovision and other VBI data will probably show up. TVs with a 16:9 feature have to blank this. |
|
#2
|
|||
|
|||
|
Thanks, Andy.
It does, indeed, still use the pots for some functions. The Bias and Drives and Pin Cushion and Horizontal Centering and Vert and Horiz size are still like the good old days. I think I might experiment with cranking the pot that's there first to see how it looks before going further. I'm not really a technician, but I know some basics. The idea of having additive resistance is a good one. I hadn't thought of what would happen in that split second when there is no signal at all between the two values. I guess it could fry something to concentrate the beam at full bore on a single raster line. The problem I have with the pots is that they seem frail. After so many years, the Bias and Drive controls have gotten non-linear. It takes a lot of patience and even more luck to get an acceptable setting for those. I would hate to think that the vertical size is just as frail, but I bet it is. Thanks again! |
![]() |
| Thread Tools | |
| Display Modes | |
|
|