Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Rectangular Screen Tube Televisions

Notices

We appreciate your help

in keeping this site going.
Reply
 
Thread Tools Display Modes
  #1  
Old 12-16-2007, 11:12 AM
jpdylon's Avatar
jpdylon jpdylon is offline
<-- sucker for old sets.
 
Join Date: Apr 2005
Location: Knox County, Tennessee
Posts: 1,675
what is the grid voltage on the Horizontal output when the failure starts occurring? If the HO is loosing bias it will greatly effect the sweep and size. The oscillator is responsible for biasing the HO tube, so you might see if the HO oscillator is ok. If you have a scope, look at the waveform at the output of the oscillator for a clean looking sawtooth around 17.5 khz

In some cases like this its sometimes best to simply sub out the HO and damper to make sure its not either of those two tubes. tube testers will test basic emission and shorts. Most don't have enough supply voltage to test sufficiently for leakage. It may show as good, but after the tube heats up driving the Horizontal sweep and HV section, it can be bad in circuit.

What HO and damper does it use? I may have them kicking around here somewhere.
__________________
Jordan
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:16 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.