Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early Color Television

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #9  
Old 11-06-2007, 11:59 AM
freakaftr8's Avatar
freakaftr8 freakaftr8 is offline
Convergence freak!
 
Join Date: Sep 2007
Location: Folsom, CA (no not in the prison)
Posts: 1,778
Thanks for the input on that, it's good to know that others are keeping up to date on my project (that my wife shakes her head at). lol, but heres the scoop. I bought this digital capacatince meter and it seems to work well, but I noticed with it's better to lift one leg off the board to test. What I have noticed is that after I replaced all the lytics in the power supply, I tested the new caps last night in which 3 of them are 450v 100mfd instead of the original can cap rating of 450v 80mfd. One cap reads 147mfd. I have schematics on this set and I am fairly intellegent on reading them however there are just a few things I need to brush up on..



Quote:
Originally Posted by jpdylon View Post
I would not go replacing caps following assumptions. THe problems you are facing are due to defective components, but you need to properly troubleshoot the set before you can come to a conclusion as to what part is really at fault. Do you have a schematic and a receiving tube manual? If so you can compare voltage readings on the tubes with what is in the schematic. If something is terribly wrong (ie 2v where it should be -10) it can be easily determined what is causing it. I can send you a scan of the IF and video sections of the CTC-16 chassis if you can give me an email address.

Unless you like throwing money at caps you may not need, you really need a good capacitance tester that measures leakage. Simple digital multimeters aren't good enough because they do not supply enough voltage to cause the suspect cap to malfunction. A real capacitance tester will put anywhere from 1-1000v through a cap to ensure there is no leakage. Sometimes you can use an old VTVM and use it on the AC function to measure leakage on a capacitor. An ESR meter is good as well, but only really for electrolytics and no for film mica, or ceramic caps.

The ceramic and films caps do not fail as often as electrolytics, but they do fail. If there is smearing on a black and white picture as well as color, I would look to video and IF circuits. YOu can take out the bandpass amp, color amp and 3.58 tubes to render the color circuits inoperative. This may better help you to isolate the video smearing problem.

The vertical shrinkage is attributable to drifting grid resistors on the vertical output tube, and faulty electrolytic (big silver can on the vertical board) As a precaution if I experience that shrinkage problem I will shotgun the board with all new caps and check the resistors on the board for drift. Its ok to see a slightly lower resistance than the printed value while in the circuit board. However, if the value taken is more than 10% of its actual printed value, the I will replace it.
__________________
Honey, turn on the tv.. I'm cold!
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:22 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.