![]() |
|
|
|
#1
|
||||
|
||||
|
Answer: someone who needs a powersupply, an outer plastic frame, rear case, feet etc would pay decent money for it on ebay. Never forget the person who needs a dead one to fix his own.
|
|
#2
|
|||
|
|||
|
Quote:
I've more then once brought something back to life using "cadavers" from other dead electronics. |
|
#3
|
||||
|
||||
|
Plasma, LCD, DLP, ETC.
I work part time in a TV shop in Miami Fl. that has been in business since 1953. People still bring in their beloved electronics from the 1950's thru 1970's and when one or two come in I get called to repair them. They are also the authorized service center for companys the build/sell plasma, LCD, and DLP sets. What I have seen that if the problem cannot be corrected by software upgrades, (quite a few can ) or the replacement of large circuit boards the manfacturer says to tell the customer that the device is not economicilly repairable. If under warranty the bad section is replaced, they usually ship second day air. There are a lot of folks with 5 year old plasma sets who are very unhappy after pitching their 15 year old still working CRT rear projection sets to make room for the new flat screen technology.
|
|
#4
|
||||
|
||||
|
I understand that; but, it would be just my luck that the same part I needed would be bad in the busted plasma I just paid $500 for. The only way I'd consider paying any large amount of $$ for anything broke would be if I knew for certain that it had a good part for something else I needed. It will be interesting to see what new plasma sets sell for in 10-15 years. I wonder if they will ever be as cheap as most current CRT sets are.
|
|
#5
|
|||
|
|||
|
With modern electronics, the extremely complex integrated circuits and the surface mount technology(not to mention the lead-free soldier that is coming) is making board repair at the local TV shop very difficult. At the manufacturers location, special test fixtures(such as bed of nails, special test equipment to exercise the ICs test modes, etc) would make more economic sense than at an individuals TV shop. This would also be true of the specialized equipment needed to reliably replace surface mount components.
This is my opinion as to why board replacement, not repair is being done at most electronic service locations today. (It is also the reason that I try to avoid working on any electronic equipment made after about 1985-not only are the components easier to replace-they are easier to find and purchase, including vaccum tubes.) |
| Audiokarma |
|
#6
|
||||
|
||||
|
Quote:
It was only four and a half years ago that 42" non-high-definition plasma displays went down to US$3000-3500, and now the near-high-def ones are under $1000. A 37-inch LCD in Japan cost the equivalent of $7500 in January 2003, and I have seen that size recently for well under $1000. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|