Quote:
|
Also I use a 300 ma fuse or a 6.3 volt 250 ma lamp bulb in the cathode circuit of the color set horizontal output. The lamp allows you to adjust the current just by watching the brightness.
|
I think we might have studied the same TAB Books color tv service book from 1968 at one point. I use a plug-in version of the "#44 lamp as plate-current indicator" to find the dip that marks the proper setting of the Horiz. Efficiency coil also. My version uses a mini bayonet lamp socket insulated with shrink tubing. One lead has a plate cap socket salvaged from a dud flyback, the other has a plate cap taken from a dud 6CB5 or similar output tube. If I'm reasonably sure I've fixed all problems in a Horiz Sweep circuit, I insert this device in series with the plate cap for the first post-service power-up just in case I might have missed something and leave it there during the Horiz. Efficiency coil adjustment. One of these days, I hope to find some spare time to make up a "bias probe" device to insert between 6BK4 or similar HV Reg. tube and socket to provide easily-accessible metering connections during regulator current adjustment. I was 8 years old when I did my first paid radio repair, so I've been at this 30 years now between working for tv, vcr and audio shops, hobby work, and "serial temp jobs" in contract engineering and industrial maintenance. My high school social life, a collection of LP's and CD's, audio gear, and the guitars I played in several "nameless garage bands" were all financed by repairing tv sets independently and/or for local shops. My interest in vintage electronics started around age 12 when my grandfather found an antique radio in the attic of a house he was restoring, although I'd been working with tubes in tv and via an interest in guitar for a couple of years by then.