Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #26  
Old 09-29-2007, 09:12 AM
John Folsom's Avatar
John Folsom John Folsom is offline
VideoKarma Member
 
Join Date: May 2004
Location: Melbourne Florida
Posts: 932
I would locate the resistor right after the 6X5, that way you keep the voltage on the filters to a minimum. The max DC current for the 6X5 is 75mA, so (325-175)/.075= 2000, and 11.5 watts, as a worst case.
At 5000 ohms, 150/5000=30mA, and 4.5 watts. I would try the 5K ohm 5 watt resistor. Bring it up on a variac and monitor the voltage, and adjust the resistor value and wattage as required.

As for the filaments, try to keep the current rating and the actual load close to each other. Paralleling the outputs when you don't need to will make the filament voltage run on the high side. You may have to add up all the tube load currents by hand to determine your actual requirement if Sams does not give it.

Good luck.
__________________
John Folsom
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:47 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.